II. Technique Parameters
1.Applicable welding length :according to drawing
2.Applicable material :Stainless steel,carbon steel,Aluminum
3.Rotation speed :1-8r.p.m
4.Air pressure :0.4-0.6MPa
5.Welding gun adjustment :30mm (up&down, left&right)
6.Rotation degree :30°~60°
7.Machine working voltage :380v 3phase 50hz for welding power source ,220v single phase 50hz for main machine
III. Machine Structure
1.In order to meet welding requirement, welding torch can be adjusted up and down(cylinder driven),
side to side and angled turn (servo motor driven). They maximize throughout, and welding deformation
can be reduced significantly
2. Japan OMRON PLC and touch screen are used to control the whole machine. With the help of touch
man-machine interface, welding mode and specification can be preset,stored and retrieved. Welding
original point can be auto-detected. Welding torch will go to mechanical point after finishing the seam
3. Push-type wire feeder works stably. Machine is with high welding voltage and slow wire feeding
performance, which guarantees reliable arc igniting. Machine is also with low welding voltage and low
welding current for filling crater
4. We will arrange jig and fixture for your workpiece. Take right position of workpiece. Get center of
bottom.
5.1 set power source and 1set water chiller will go with machine